To Next PageTo Next Page
Need help?Do you have a question about the Trane GAM5A0A18M11SAA and is the answer not in the manual?
General| Product Category | Air Handlers |
|---|---|
| Model Number | GAM5A0A18M11SAA |
| Nominal Cooling Capacity | 1.5 Tons |
| Voltage | 208/230V |
| Phase | 1 |
| Motor Type | PSC |
| Cabinet Type | Upflow/Horizontal |
| Filter Type | Disposable |
| Width | 17.5 inches |
| Height | 44 inches |
Details hazards like electrical, vapor, corrosion, and sharp edges, with specific warnings.
Provides a table of vapor and liquid line connection sizes for various models.
Details panel removal and preparation steps before brazing refrigerant lines.
Covers brazing connections, pressurizing the system with nitrogen, and performing leak checks.
Details system evacuation procedures and replacing the line set panel.
Lists important considerations for condensate drain lines: compliance, routing, slope, and connections.
Describes the steps for connecting the primary and secondary condensate drains using PVC pipe.
Describes routing control wiring and removing the coil panel for access.
Illustrates the low voltage wiring connections for cooling mode operation.
Covers heat pump wiring, securing cables, and setting the refrigerant switch.
Provides tables for system charge adjustments to maintain rated HSPF based on unit combinations.
Details the steps for ensuring panels are secure, powering up the system, and setting the thermostat.
Describes the sequence of operation for various modes including fan, heat pump, cooling, and electric heat.
Provides a comprehensive checklist for verifying correct installation and operation before completion.
