33
13. Heat/Cool Priority Setpoint Source is available only if
the Auxiliary Heating and the Ext Priority Setpoint options
are installed).
If a Tracer is installed, the word “Default” will appear in
front of the setpoint source.
(Default) Priority Setpoint Source:
(Source)
Selection options of (source) are Front Panel, Default-
External.
14. Hot Water Reset Type
Hot Water Reset Type: (Type)
Press (+) (-) to Change Setting
The selections for (type) are Disable-Default, Return,
Constant Return, or Outdoor Air.
When Disable or Constant Return Chilled Water Reset are
selected, there are no other selection options available.
15. Reset Ratio
This screen is displayed when Return or Outdoor Air is
selected as the Hot Water reset type.
(Type) Reset Ratio: xxx %
Press (+) (-) to Change Setting
16. Start Reset
Displayed when Return or Outdoor Air is selected as the
Hot Water reset type.
(Type) Start Reset Setpoint: xxx.x F
Press (+) (-) to Change Setting
17. Max Reset
Displayed when Return or Outdoor Air is selected as the
Hot Water reset type.
(Type) Max Reset Setpoint: xxx.x F
Press (+) (-) to Change Setting
18. Heat/Cool Priority Select
Displayed when the Auxiliary Heating Option is installed.
Heat/Cool Priority: (Status)
Press (+) (-) to Change Setting
Possible values for status are:
Cooling Only, ROM Default
Heating Only
Cooling Priority
Heating Priority
19. Heat/Cool Priority Setpoint Source
Displayed when the Auxiliary Heating and EXT Priority
Setpoint is selected.
(Default) Priority Setpoint Source:
(Source)
(Source) can be either Front Panel-default, or External.
20. Fuel Select
The Fuel Select Setpoint is displayed when the alternate
Fuel Option is enabled.
Fuel Select: (Source)
Press (+) (-) to Change Setting
(Type) will be either Gas-default or Alternate.
21. Fuel Select Setpoint Source
Displayed when the alternate Fuel is selected.
(Default) Fuel Select Setpt Source: (Source)
(Source) will be either Front Panel-default, or External
22.
Setpoint Source Override:
(Source)
The options are: “None” - “Default,” Use Front Panel
Setpoints” and “Override Tracer.”
To Next Page
Loading...
