26 OAU-SVX005C-EN
System Configuration and Pre-Start
The following procedure must be completed prior to
performing the procedure in the Start-up chapter. This
section describes procedures to navigate the various
displays on the Unit Display and configure the Outdoor Air
Unit Main Unit Display system setpoints and operating
parameters.
Important: This section is intended to provide
guidelines for navigation through the
remote operator display screens. For
additional control system information, refer
to Integration Guide: Tracer™ UC600
Programmable Controller for Packaged
Outdoor Air Unit (BAS-SVP18*-EN). The
unit is configured at the factory with the
default settings.
To Next Page
Loading...
