Trane P0V0 Series Installer's Guide

18-GE20D1-1E-EN
31
Fault Code Recovery
Fault Code Recovery
1. To view the last 6 faults, press the “Menu” key until the “Last 6
Faults” (L6F) menu appears.
2. Enter the menu by pressing the “Option” key.
3. The last 6 faults can be viewed.
Clearing the Last 6 Faults
1. To clear the last 6 faults, press the “Menu” key until the “Last 6
Faults” (L6F) menu appears.
2. Enter the menu by pressing the “Option” key.
3. Hold the “Option” key for at least 5 seconds.
4. Release and a set of 3 dashes with be seen 3 times. This confirms
the faults have been cleared.
Resetting Factory Defaults
1. Display must be in Idle Mode.
2. Push the “Menu” and “Option” buttons at the same time for 15
seconds then release.
3. The 7 segment will flash “FD” 3 times. This confirms the unit has
been reset to the factory defaults.
Motor
Communications
Personality
Module
Low Voltage Terminal Strip
12 Pin
Connector
LINE
Connections
EAC, HUM
Dry Contacts
Neutral
Connections
7 Segment LED
MENU and OPTION
Select Buttons
5 Amp Fuse
BK Jumper
FP
HLI
BK W2 W1 R G B/C Y2 Y1 O
MVH
MVL
GND
PS2
TH
MVC
HLO
PS1
TR
ILI
IInntteeggrraatteedd MMoodduullaarr BBlloowweerr CCoonnttrrooll ((IIMMBBCC)) DDiissppllaayy CCooddeess

Trane P0V0 Series Specifications

General

Brand	Trane
Model	P0V0 Series
Category	Blower
Language	English