Installation
RT-SVX24J-EN 65
6. Use screw gun to unscrew the two screws that hold the
fan shipping bracket.The bracket should drop down
but still remain engaged with a hook on the bracket.
7. Go to the other side of the unit and follow the
procedure for inlet louver and
door removal
(see steps1-6).
8. Hold the
bracket with one hand and remove remaining
two screws.
9. Remove
the bracket and all the removed screws from
the unit.
Important: Make sure there are
no screws remaining in
the coil area.
10. Reinstall inlet louvers, mist eliminators and louvers.
11. Check that the direction of arrow on the inlet louver is
correct.
Figure 42. Removing fan assembly shipping hardware
Figure 43. Removing compressor shipping hardware
Note:
Shims are located in the center, and on
the four corners, of each set of
compressors.
To Next Page
Loading...
