No. Description Warning Alarm Trip Lock Parameter Reference
2 Live zero error (X) (X) 6–01
3 No motor (X) 1–80
4 Mains phase loss (X) (X) (X) 14–12
7DC over voltage (X) (X)
8DC under voltage (X) (X)
9 Inverter overloaded (X) (X)
10 Motor ETR over temperature (X) (X) 1–90
11 Motor thermistor over
temperature
(X) (X) 1–90
13 Over Current (X) (X) (X)
14 Ground fault (X) (X) (X)
16 Short Circuit (X) (X)
17 Control word timeout (X) 8–04
24 Fan Fault (Only on 400 V
30-90 kW)
(X) 14–53
30 Motor phase U missing (X) (X) 4–58
31 Motor phase V missing (X) (X) 4–58
32 Motor phase W missing (X) (X) 4–58
38 Internal fault (X) (X)
44 Ground fault 2 (X) (X)
47 Control Voltage Fault (X) (X)
48 VDD1 Supply Low (X) (X)
50 AMA Calibration Failed (X)
51 AMA check U
nom
and I
nom
(X)
52 AMA low I
nom
(X)
53 AMA motor too big (X)
54 AMA motor too small (X)
55 AMA Parameter out of
range
(X)
56 AMA interrupted by user (X)
57 AMA timeout (X)
58 AMA internal fault (X) (X)
59 Current limit (X)
60 External Interlock (X)
66 Heat sink Temperature Low (X)
69 Pwr Card Temperature (X) (X) (X)
79 Illegal PS cong (X) (X)
80 Drive Initialised to Default
Value
(X)
84 LCP Error X
87 Auto DC Braking (X)
95 Broken Belt (X) (X)
22–6
*
201 Fire Mode (X)
202 Fire M Limits Exceeded (X)
250 New spare parts (X) (X)
251 New Type Code (X) (X)
Table 4.2 Alarm/Warning Code List
(X) Dependent on parameter. A trip is the action when an
alarm has appeared. The trip coasts the motor and can be
reset by pressing [Reset] or make a reset by a digital input
(parameter group 5-1
*
Digital Inputs [1]). The original event
that caused an alarm cannot damage the frequency
converter or cause dangerous conditions. A trip lock is an
action when an alarm occurs, which can damage the
Troubleshooting TR150 and TR170 Service Manual
BAS-SVM04B-EN 02/2017 All rights reserved. 33
4
To Next Page
Loading...
