8.2.2 Cable Mounting Plate
1. Remove the ribbon cable.
2. Remove 1 screw (T20) from shield metal.
3. Use a
at
screwdriver to release the retainers and
connection terminals.
4. Use a hex 4 key to loosen the screws in the cable
connector.
5. Pull out the cables.
6. Slide the connector to the side and remove it.
7. Remove 2 screws (T20) from the mounting plate.
Reinstall in the reverse order.
1EMC shield
2Cable mounting plate
Illustration 8.2 Cable Mounting Plate
8.2.3 Heat Sink Fan Assembly
1. Unplug cable from power card.
2. Remove 2 screws (T20) from the fan mounting
plate.
3. Push the cable downwards. Use a screwdriver to
press the gasket down through the entry.
4. Pull out fan assembly.
Reinstall in the reverse order.
1Fan cover
2 Fan assembly
Illustration 8.3 Heat Sink Fan Assembly
I-Frame Size Disassembly an...
76 02/2017 All rights reserved. BAS-SVM04B-EN
8
To Next Page
Loading...
