I STALLER'S GUIDE
CHECKOUT PROCEDURE WITH MAiN POWER DISCONNECTS CLOSED (ON)
indoor
Step
No.
TO CHECK
t Sump Heat
2 indoor FanOperation
3 Cooling Operation
4 CheckingPerformance
& Charge
5 HeatingQ
6
iNDOORTHERMOSTAT
SWITCH SETTING
Q G Fan Switch
Off Cool Heat Auto On
X X
X X
X X
I x x
4
Blower
Runs
X
X
X
USE CHARTS ATTACHED TO O.D. UNIT
I x N !
COMPONENTOPERATION
Outdoor
Fan Compressor
Runs
Runs
X X
I x x I
I
inform owneron howtooperatesystemandwhat to expectof it. At the sametime deliverOwner'sUseand Care Booklet.
Comp.
Sump
Heater
X
X
X
X I
N
Also set thermostat dial to call for cooling or heating as necessary.
@ Check only necessary if heating unit is used for indoor section and wiring has been disturbed during installation of cooling
equipment
Furnace
Heat
Comes On
P
X
Since American-Standard has a policy of continuous
product and product data improvement, it reserves the
right to change design and specifications without notice
Technical Literature - Printed in U.S.A.
TheTraneCompany
Unitary Products Group
6200 Troup Highway
Tyler, TX 75707
PAGE 8 Pub. No. 18-AC34D1-5
P.I.
To Previous Page
Loading...
