©American Standard Inc. 1999 TWE5-PRC001-EN-10-15-99
Features and
Benefits
TWA
TWJ
TWE
Air Handling Units
Condensing Units
Benefits:
• Flexibility in application
• Quality and reliability
• Uniform covering for a smooth, attractive
and corrosion-resistant finish
New Features
• Improved filter access and latch -
Eliminate current T-bar and shipping
bracket.
• Provision for 1-1/8 inches thick field
supplied electrostatic filter
• Reversible Duct Flanges - Fits up to
1-1/2 inches duct board
• Improve controls access with control
box mounted next to blower.
• 40 VA transformer with 5 amp automo-
tive style fuse on 3 tons and less
• 5 Amp automotive style fuse replaces
Bussman “red cap” fuse on 3.5 to 5 ton
models
• Blower mounting brackets improved -
Front access to screw with power driver
• Improved bottom carton cushioning
• 1 inch thick foil faced insulation for all
models
Features
• Ships horizontal
• Six way convertibility-horizontal (left and
right), upflow, downflow (front and rear
access)
• Electrical, refrigerant, condensate and
blower access convertible to either side
• Corrosion resistant galvanized steel
with attractive finish
• Internally enhanced finned coil tubes
• Direct drive motor
• Standard filters
• Multi-speed blower
• 220 volt primary and 24 volt secondary
transformer
• Insulated cabinet
• External access to heater circuit
breakers
• Start kits are not required
• Built-in indoor fan delay function for
increased efficiency. No kit required.
Features:
• Vertical Air Discharge
• High Efficiency TRANE Climatuff
®
Compressor
• Powder Paint finish
• Brazed connections
• Spine Fin™ Outdoor Coil
• Switchover Valves
To Next Page
Loading...
Need help?
General
