Need help?Do you have a question about the Trane Voyager YC* and is the answer not in the manual?
General| Brand | Trane |
|---|---|
| Model | Voyager YC* |
| Category | Air Conditioner |
| Language | English |
Overview of Trane's Voyager packaged rooftop product line, highlighting its features and benefits.
Lists standard features of Voyager units, covering components like filters, warranty, and design.
Details available factory-installed and field-installed options for enhanced functionality and customization.
Information on Voyager's low ambient cooling capability and necessary options for these applications.
Maintaining recommended clearances for serviceability, peak capacity, and efficiency is crucial.
Procedure for calculating and selecting units based on building cooling loads and conditions.
Procedures for calculating heating capacity differ for TC* and YC* units, requiring building load calculation.
Details the cooling capacity digits corresponding to tons and efficiency levels.
Lists factory-installed options corresponding to digits 9 and 10 in the model number.
Provides explanations and clarifications for various model number digits and options.
Provides key specifications for 12½-15 ton units, including cooling, compressor, coil, and fan data.
Provides gross cooling capacities for 12½ ton standard efficiency units across various conditions.
Details gross cooling capacities for 15 ton standard efficiency units under different ambient conditions.
Overview of ReliaTel controlled units and available zone sensor options for occupant comfort.
Details standard fixed dry bulb control and optional enthalpy/differential enthalpy controls.
Wiring information for units with gas heat or cooling, detailing ampacity and fuse/breaker sizes.
Electrical characteristics for evaporator fan motors, detailing amps, voltage, HP, and motor types.
Details the typical number of wires required for zone sensors and thermostats.
Wiring diagram for cooling units with optional electric heat, showing connections.
Wiring diagram for gas/electric units, illustrating connections for specific wiring.
Dimensional drawing of cooling units with electric heat/gas/electric models, showing standard and high efficiency.
Dimensional drawing of cooling units (20-25 tons standard, 15-25 tons high efficiency) with electric heat/gas/electric.
Standard efficiency unit dimensions (A-K) for cooling and gas/electric models.
Unit and corner weights, and center of gravity dimensions for cooling units with electric heat.
Unit and corner weights, and center of gravity dimensions for gas/electric heat units.
Details casing construction, materials, finishes, insulation, and service access.
Details the gas heating section, including heat exchanger, blower, ignition system, and gas valve.
Lists factory installed options such as Black Epoxy Coated Coils and Dehumidification Option.
Thermal magnetic circuit breaker option for through-the-base electrical connections.
Lists options like Clogged Filter/Fan Failure Switch, Differential Pressure Switches, and Discharge Air Sensing Kit.
Fully modulating economizer with barometric relief, minimum position setting, and wiring harness.
Designed to mate with downflow units, providing support and watertight installation with NRCA compliance.
Allows unit transition to sequences for smoke purge, pressurization, and exhaust via binary input.
To Next Page