EasyManua.ls Logo

Trane VR8GE Series - Installation Checklist; Replacement Parts

Trane VR8GE Series
32 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTALLATION CHECKLIST
GAS SYSTEM
Gas Type: (circle one)
Natural
Gas
Propane
Gas pipe connections leak-tested? YES NO
Gas Line Pressure (in - W.C.):
Is there adequate fresh air supply
for combustion and ventilation?
YES NO
Installation Altitude (FT.):
Deration Percentage:
Unit Input (Btuh):
Supply Air Temperature (° F):
Return Air Temperature (° F):
Temperature Rise (° F):
DURING UNIT OPERATION:
Manifold pressure (in - W.C.):
REFRIGERATION SYSTEM
Was unit given 24 hr warm up
period for crankcase heaters
(if equipped)?
YES NO
Stage-1 Liquid Pressure (high side):
Stage-1 Suction Pressure (low side):
INSTALLATION ADDRESS:
CITY: STATE:
UNIT MODEL #
UNIT SERIAL #
Unit Installed Minimum clearances
per Figure 1 (page 5)?
YES NO
INSTALLER NAME:
CITY: STATE:
Has the owner’s information been
reviewed with the customer?
YES NO
Has the Literature Package been
left with the unit?
YES NO
ELECTRICAL SYSTEM
Electrical connections tight? YES NO
Line voltage polarity correct? YES NO
Rated Voltage (VOLTS):
L1-L2 Volts:
Has the thermostat been calibrated? YES NO
Is the thermostat level? YES NO
Is the heat anticipator setting
correct? (If Applicable)
YES NO
VENTING SYSTEM
Is the vent hood installed? YES NO
Is vent hood free from restrictions YES NO
Filter(s) secured in place? YES NO
Filter(s) clean? YES NO
ATTENTION INSTALLERS:
It is your responsibility to know this product better than your customer. This
includes being able to install the product according to strict safety guidelines
and instructing the customer on how to operate and maintain the equipment
for the life of the product. Safety should always be the deciding factor when
installing this product and using common sense plays an important role as well.
Pay attention to all safety warnings and any other special notes highlighted
in the manual. Improper installation of the unit or failure to follow safety
warnings could result in serious injury, death, or property damage. These
instructions are primarily intended to assist qualified individuals experienced
in the proper installation of this appliance. Some local codes require licensed
installation/service personnel for this type of equipment.
Specifications & illustrations subject to change without notice or incurring obligations (04/22).
O’Fallon, MO, © Nortek Global HVAC LLC 2022. All Rights Reserved.
10422360
(Replaces 1036144A)
REPLACEMENT PARTS
Replacement parts are available through your distributor. Please
have the complete model and serial number of the unit when ordering
replacement parts.
ELECTRICAL:
• Capacitors Pressure Switches
• Compressors • Relays
• Contactors Temperature Limit Switches
Gas Valves • Thermostats
Ignition Controls Time Delay Relays
Ignitors/Flame Sensors • Transformers
MOTORS:
Blower Motor
Fan Motor
Inducer Blower Motor
COMPONENTS:
Blower Assembly Fan Grille
Burner Manifold • Filter/Driers
• Burners/Orifices • Gaskets
Cabinet Panels Heat Exchanger
Expansion Valves

Table of Contents

Related product manuals