32 BAS-SVX40A-EN
Appendix: Using the Tracer™ TU Service Tool with Wireless Networks
Figure 22. Advanced tab
Wireless Zone Sensor Enable/Disable
If a unit controller’s WCI is a zone sensor receiver, the zone sensor is detected and the necessary
references are created automatically. The wireless sensor enable/disable setting in the Setup
Parameters screen is enabled (checked) by default. However, if a wired sensor is connected to the
unit controller, but a wireless sensor is in the area, the wireless sensor has priority and the unit
controller may start using the wireless sensor even though a sensor is wired to it. In such a case,
you must disable (de-select) the wireless sensor enable/disable setting.
Figure 23. Wireless sensor enable/disable
To Next Page
Loading...
