•
• FITTING THE TRANSCEND H
6
B AND TRANSCEND
H
9
M WATERLESS HUMIDIFICATION SYSTEMS
3
FITTING
Transcend H
6
B Waterless Humidification System
1. Put on the Transcend H
6
B interface and headgear without the hose attached.
The rear headband sits at the nape of the neck.
2. Fit the mask so the forehead pad rests just above the brow line.
3. If the mask does not fit so the forehead pad rests just above the brow line,
change out the arm bar to the appropriate size. To change out the arm bar,
rotate it out of the forehead piece, then remove the arm bar from the mask
by pinching the sides to release it from the slide adjustment. Select another
size arm bar and fit it into the mask slide adjustment and forehead piece.
1
Chapter 3 • Fitting Your Transcend • page 11
To Next Page
Loading...
