30
depends on the surroundings including the weather and the location it is being used (e.g. high
buildings, tunnels, undergrounds and forests). On first use or cold start, please place the
DrivePro Body in an outdoor open area for GPS positioning.
Adhesive mount usage
The adhesive pad is recommended for use on smooth surface.
Application instructions:
－ Clean the area where the adhesive pad will be placed.
－ Allow at least 24 hours for the mount to properly adhere to the surface.
10. IP67 Protection
The camera body of the DrivePro Body 60 is rated at IP67, offering splash, water, and dust
resistance. However, splash, water, and dust resistance are not permanent conditions and
resistance might decrease as a result of normal wear. Liquid damage is not covered under warranty.
WARNING: DrivePro Body 60 is not water resistant when connected to the power
cable or when any of the screws is removed from the main unit.
Failure caused from incorrect use is not covered by the limited warranty.
Do not use the DrivePro Body 60 in water as it is not waterproof.
Do not use the DrivePro Body 60 in high temperature and high humidity environments (i.e.
saunas, steam and shower rooms).
Do not use the DrivePro Body 60 for a long time in heavy rains to avoid the moisture from
penetrating. Make sure the power cable, adapter and connection socket are completely dry
before charging.
To Next Page
Loading...
