EasyManuals Logo

Transfer Flow TRAX 4 User Manual

Transfer Flow TRAX 4
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
How accurate is my main tank fuel gauge after installing TRAX 4™?
The accuracy of the main fuel gauge will not change.
I previously bought a Transfer Flow auxiliary tank. Can I transfer it
to my new truck?
It depends on the truck you are buying. TRAX 4™ is only available for 2008 to
current model years. You may need to purchase a re- installation kit. Call our
fuel system experts for more information at (800) 442-0056.
Why do I see my fuel level percentage uctuate ±10% in the rst
two minutes of operation?
The module is rapidly calculating the fuel level in each tank to determine the
most accurate value. Fluctuations should slow after a few minutes of operation.
Why is “ERROR” displaying when my system is brand new or the
lter is clean?
This may be due to an individual’s driving habits, driving conditions, or fuel
sloshing in the main or auxiliary tank. The “ERROR” condition will reset after 20
minutes or by cycling the ignition (turning it o then on again).
The fuel levels displayed on the mobile app change when cornering
hard or during other rapid motions. Is this normal?
Yes, your Transfer Flow fuel tank system has been designed to keep fuel
sloshing to a minimum. However, it is not possible to completely eliminate all
fuel sloshing. Many times, you will nd that fuel sloshing will be greater in the
main tank compared to the Transfer Flow tank. This is because the Transfer
Flow tank is fully baed while most main tanks are not. In either case, you
should not see a fuel level change of more than ±10%, except under periods
of high cornering, braking, or acceleration loads. If your main tank is close to
empty, you may see your vehicle’s low fuel light turn On and O.
If the TRAX 4™ system develops a problem, what do I do?
Consult the troubleshooting table on Page 11 or deactivate the system by
disconnecting the power to the computer module, located near the OBDII
connector/port. Reference the “TRAX 4™ Computer Module Overview” diagram
on Page 8; disconnect the red OBDII connector that goes to the Transfer Flow
wire harness. The vehicle will now operate from the main tank only. Please call
Technical Support at (800) 442-0056 x2 or (530) 893-5209 x2 if you ever have
this issue.
Frequently Asked Questions
9

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Transfer Flow TRAX 4 and is the answer not in the manual?

Transfer Flow TRAX 4 Specifications

General IconGeneral
BrandTransfer Flow
ModelTRAX 4
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals