Transition Networks S3290 - Features

Transition Networks, Inc. S3290 Install Guide
33594 Rev. D https://www.transition.com Page 6 of 30
Features
• Two/four 10/100/1000Mbps Base–T ports. Four/two 100/1000Mbps SFP ports. Any port can be
network (NNI) or client (UNI).
• Two of the SFP ports support a proprietary 2.5Gbps mode.
• TP ports support IEEE 802.3az Energy Efficient Ethernet for power saving.
• Full bandwidth 1000Mbps switching, non blocking.
• SNMP v1, v2c, and v3.
• IPv6 and IPv4 support.
• VLAN (802.1Q) Q-in-Q (C-Tag / S-Tag).
• RMON and Syslog.
• OAM Support: IEEE 802.3ah Link OAM, IEEE 802.1ag Service OAM, ITU-T Y.1731 Performance
Monitoring, and MEF E-LMI.
• Loop Protection: ITU G.8032 and IEEE RSTP, MSTP.
• G.8031 Linear Protection switching
• IEEE 1588v2 PTP (Precision Time Protocol).
• DC or AC power input (12VDC Barrel connector or 2-Pin, 21-60VDC Terminal block).
• Jumbo Frame Support (10240 bytes maximum).
• Wire speed loopbacks.
• RFC 2544 Traffic Generation and Reports.
• Last Gasp/Dying Gasp notification via SNMP trap. Monitor Rx and Tx Dying Gasp for each port.
• SNMP traps configurable: System (Warm Start, Cold Start); Interface (Link Up. Link Down, LLDP);
AAA (Authentication Fail); Switch (STP, RMON).
• Alarm inputs/outputs: RJ-45 connector with 2-IN and 2-OUT, 10-30VDC, 40mA maximum; optically
isolated from main board. Alarm indications via Syslog and SNMP.
• E-LINE (EPL and EVPL) / E-LAN (EP-LAN and EVP-LAN) / E-ACCESS (ACCESS EPL and EVPL)
/ E-TREE (EP-TREE and EVP-TREE).
• UNI or NNI configuration.
• TOS (Type of Service) and Diffserv (Differentiated services).
• QoS (802.1p Quality of Service): 8 queues; strict priority and DWRR, shaping, policing, P-bit and
DSCP.
• Management via Industry standard CLI, Web, SSH/SSL & SNMP (v1, v2c, v3).
• Port configuration, status, statistics, and monitoring.
• RADIUS, TACACS+ and ACL.
• Remote backup / restore configuration / firmware upgrades.
• L2CP (Layer 2 Control Protocol).
• LLDP (Link Layer Discovery Protocol).
• Port Mirroring and Remote Mirroring.
• Link Aggregation Control Protocol (LACP).
• DDMI (Digital Diagnostics Monitoring Interface).
• HQoS (Hierarchical Quality of Service) with Guaranteed Bandwidth Rate.
• JSON (JavaScript Object Notation) RPC.
• LLDP-MED per TIA-1057.
• MEP BFDs (Bidirection Forwarding Detections).
• MEP Route Trace.
• PFC (802.1Qbb Priority Flow Control)
• Traffic Test Loop (Y.1564, RFC2544, and TT-Loop functions).
• UDLD (Uni Directional Link Detection) protocol support (RFC 5171).
• Y.1564 Tests and Reports.