Normally, Timer T1 is set at about 0.3 seconds, but may have to be adjusted
Timer, T1, bearing in mind the time required for strapping the minimum-size package.
This Timer, T1, determines the time necessary for strap take-up. Set
Timers 30 & 29
Timer, T1 30 ：
depending on a package size.
Timer, T2 29 ：
This Timer, T2 determines the Time necessary for strap feed. If the
time selected for Timer T2 is too short, strap may not reach the sealing position.
Normally, Timer T2 is set to about 0.7 seconds for standard arch (850x600), but may have
to be adjusted depending on arch size.
-8-
b. (For Single Phase)
To Next Page
Loading...
