7. How to Operate
-10-
Trouble-Free Operation
8. Recommendations for
(1)
Turn the power supply switch on.
The pilot lamp lights up and the strap
For standard version ：
(1)
Make sure to turn off the power supply
For CE version：
Turn on the switch (make a 90-degree
is automatically fed into the Accumulator
Box. If you want to open the front door,
automatically fed into the Accumulator
at the same time and the strap will be
clockwise turn). The front door will lock
can now open the front door without risk.
counterclockwise turn). The operator
turn off the switch first (make a 90-degree
(See drawing below)
(2)
Turn F/R switch counterclockwise.
P.P. strap is fed into the arch track.
Keep turning the F/R switch until
the strap reaches the sealing position.
It is now ready for strapping.
(3)
Wait for about 3 minutes until
the heater element has reched its
required operating temperature.
(4)
Place a package on the center
of the strapping head. Push the start
switch 1 (P.2), and the package
strapping operation is repeated if
is automatically strapped. The
the start switch is pushed again.
(5)
After operation, turn off the
power supply switch.
switch , when maintenance and/or
exchange of strap coil is required.
(2)
Pull the strap out of the Accumulator Box
and rewind it on the Reel Unit to prevent
cambering, if the machine will not
be used for long periods of time.
(3)
In order to change the strap width, use
the strap convesion kit which is sold
as an option.
When the electric plug receptacle has
(4)
to be changed, check the revolving
direction of motor. (P5 NO. 15 ).
(5)
Always keep the machine clean, especially
by removing dust and strap fluff
in the vicinity of the strapping head and
heater unit.
(6)
Do not use extension cords.
Box. (See page 2no. 4 )
To Next Page
Loading...
