13
12
Recall the Records
2. Press the “MEM” or “SET” to get the record you
want. Press and hold the “MEM” button to look
over ten groups of the historical records quickly.
The most recent record (1) is shown first. Each new measurement is
assigned to the first (1) record. All other records are pushed back one
digit (e.g., 2 becomes 3, and so on), and the last record (250) is
dropped from the list.
The current No. is No 2. The corresponding
time is P.M. 10:08.
The corresponding
date is January 2nd.
CAUTION
The date and time
of the record
will be shown
alternately.
Pul/min
MEMORY
TIME /DATE
S
M
STA RT
ST O P
Pul/min
MEMORY
TIME /DATE
S
M
STA RT
ST O P
Pul/min
MEMORY
TIME /DATE
S
M
STA RT
ST O P
DATA MANAGEMENT DATA MANAGEMENT
If you did not get the correct measurement, you can delete all
results for the selected user by following below steps.
Delete the Records
1.Hold pressing “SET”
for 3 seconds when the
monitor is in the memory
recall mode ,the
flash display “dEL ALL” will
show.
2.Press “SET” to
confirm deleting and
the monitor will turn
off.
3.If you don’t want to delete the
records, press “START/STOP”
to escape.
4. If there is no record.
Press “MEM” button,
the right display will
show.
Pul/min
MEMORY
TIME /DATE
S
M
STA RT
ST O P
Pul/min
MEMORY
TIME /DATE
S
M
STA RT
ST O P
Pul/min
MEMORY
TIME /DATE
S
M
STA RT
ST O P
STA RT
ST O P
3. If you want to look over another user’s data, switch the User button to select
the desired user. Then you can look over its historical records.
1. When the monitor is off,
please press the “MEM”,it will display the
latest record first when the records are less than
three groups. When there are more than three
groups ,it will display the average value of the
latest three records first.
To Next Page
Loading...
Need help?
General
