17
16
DATA MANAGEMENT
Recall the Records
1
2. Press “MEM” button
or “SET” button to get
the record you want.
The most recent record (1) is shown first. Each new measurement is
assigned to the first (1) record. All other records are pushed back one
digit (e.g., 2 becomes 3, and so on), and the last record (60) is dropped
from the list.
The current No. is No. 1. The corresponding
time is 9:37.
The corresponding
date is April 27th.
CAUTION
The order, date and time
of the record will be shown
alternately.
If you did not get the correct measurement, you can delete all
results by following steps below. (Take user 1 for example)
Delete the Records
1.Hold pressing “MEM” button
for 3 seconds when the
monitor is in the memory
recall mode ,the “User ID
+ dEL ALL” will flash on the
display.
2.Press “SET” button to
confirm deleting and
the monitor will display
“dEL dOnE” and then
turn off.
3. If there is no record.
the following display will
be shown.
Note: To exit the delete mode
without deleting any records,
press START/STOP button
before pressing "SET" button
to confirm any delete commands.
When the monitor is off,
please press the “MEM” button
to show the average value of
the latest three records.If the
records are less than three
groups,it will display the latest
record first. (Take user 1 for
example)
DATA MANAGEMENT
To Next Page
Loading...
Need help?
General
