Switch
Trigger
Lock
Before you start operating your MASTER 1000 mower
you should study carefully how the switch works - for
this model, it is the triggerwith- lock type.
It works in two ways.
One is by touch, by pressing the trigger down with
your finger.
The other is by activating the trigger with your
thumb - this way you can release the trigger and the
motor keeps running non-stop.
In this condition, simply activate and then release
the trigger to turn off the equipment.
Lubrication
At every 50 hours of use:
Loosen the bolts (1), remove the bar (2) as
seen in the picture.
Pull the inner flexible cord (3) for at least
a meter long, take it out and grease it,
mounting it back right after following the
inverse mounting order.
At every 30 hours of use:
Fill the transmission gearbox with grease until
it overspills from the threading.
To do this, remove the bolts (4) as seen in the
picture.
Note: Only use Master Grease 250 EPA -
Lubmaster, available at TRAPP Authorized
Technical Assistance.
3
2
1
4
Warning!
Lubrication deadlines were established
for normal use conditions.
Use only high rotation rolling bearing
grease.
To Next Page
Loading...
