Travis Industries Tempest Torch - Operation Procedures; Wet Weather Lighting; Turning the Torch Off

Operation 15
© Travis Industries, Inc. 4050608 100-01203_000
Lighting the Torch – WET WEATHER
1. Push valve control in and turn
counter-clockwise to START/HIGH
position, then release.
2. Insert a wand lighter through the
WET WEATHER LIGHTER
OPENING.
3. With the wand lighter lit, push and
hold valve control in. Torch must
light within 5 seconds. Remove the
wand lighter. After torch lights
continue to hold valve control in for
15 seconds. Note – if torch does
not light with a wand lighter directly
next to the burner with the valve
control pressed in in the
START/HIGH position, gas is not
reaching the torch.
Turning the Torch Off
1. Push valve control in and turn clockwise to the OFF position. Note – if excessive
wind or rain extinguishes the flame the safety control automatically turns gas off.