EN-29
| evation
4.6 Using "Pushing support" mode
If your e-bike is equipped with a Remote b, it has the "Pushing
support" mode, which you can use when pushing the e-bike.
More detailed information can be found → in chapter 23.4 ""Pushing
support" mode".
WARNING
Danger from accidental starting!
Starting the drive system in unsuitable situations can result in
accidents and serious injury.
► Use the "Pushing support" function only when pushing the
e-bike.
► When the pushing support is activated, hold the e-bike
securely with both hands and make sure that the wheels
are in contact with the ground.
CAUTION
Risk of injury!
If you push the e-bike with the pushing support activated, the
pedals rotate slowly and you may be injured.
► Be careful not to injure yourself on the rotating pedals when
using the "Pushing support" function.
1. If necessary, change to the support level "none".
2. Press and hold the lower button on the
Remote b to activate the pushing support
mode.
After 2 seconds the pushing support is
activated and sets the e-bike in motion as
long as you keep the button pressed.
3. Guide the e-bike with both hands and, if necessary, brake the speed
of the e-bike to your own walking speed by holding or restraining the
e-bike while pushing.
4. Switch off the pushing support by releasing the lower button.
FAZUA Original_Instrucion_US-EN.indb 29FAZUA Original_Instrucion_US-EN.indb 29 28-Feb-20 13:08:2828-Feb-20 13:08:28
To Next Page
Loading...
