Trek MARLIN+ 6 - Specifications; Drivetrain specifications; Wheel and tyre specifications; Seat post specifications

2024 Marlin+
24
Specications
Chain line (1x only)
52 mm
Chain ring (1x only)
Minimum Maximum
32T 36T
Oval rings of any size are not recommended as they will
affect motor performance and the ring will damage the
chainstay.
Rear brake mount
Minimum Maximum
180 mm, direct mount Adaptable to 203 mm
OLD
Rear Hub: 148 mm
Maximum tyre size
Note: The Marlin+ is not designed for mixed wheel sizes.
XS, S: 27.5" x 2.6" (2.4" with mudguards)
M, L, XL: 29" x 2.6" (2.4" with mudguards)
NOTICE: Measurements of actual tyres may vary. Always
verify that there is sufcient clearance between the tyre
and the frame. Improper tyre size could damage the
bicycle frame. Trek recommends 6 mm clearance above
and on the sides of the tyre.
Seat post
WARNING
Always follow the seat post manufacturer’s minimum
insertion recommendation. Failure to follow the recom-
mendation could cause damage to the seat post and
result in injury to the rider.
Minimum insertion: Refer to seat post manufacturer
Maximum insertion
Extra Small: 210 mm
Small: 240 mm
Medium: 290 mm
Large: 320 mm
Extra Large: 370mm
Seat tube inside diameter: 31.6 mm
Seat tube post-clamp outer diameter: 36.4 mm
Fork
WARNING
Exceeding the recommended maximum fork length could
damage the bicycle and result in injury to the rider.
Travel
Sag
Axle to Crown
Frame/Size Axle to Crown (mm) Travel (mm)
XS Recommended 492 100
Maximum 504 110
S Recommended 512 120
Maximum 524 130
M, L, XL Recommended 531 120
Maximum 543 130
Recommended sag: Refer to the suspension calculator at
Trekbikes.com/suspension-calculator.
Kickstand mount
Compatible kickstand — W330289