AIR/PRO - USA
-11-
ACCESSORIES
Please use only Trend original accessories.
Ref. AIR/P/1 THP2 filter pack (pair)
Ref. AIR/P/3C Visor overlay - clear
(pack of ten)
Ref. AIR/P/4 8 hour battery
Ref. AIR/P/5/L/USA 120V charger
Ref. AIR/P/6 Ear defenders (pair)
Ref. AIR/P/7 Remote battery
charger cradle
Ref. AIR/WIPE Airwipes (100 wipes)
Ref. WP-AIR/05/USA Sweatband available
for users with smaller
craniums.
MAINTENANCE AND CARE
AIR/PRO Cleaning
After using the AIR/PRO follow the procedure
below:
AIR/PRO should not be cleaned with
compressed air, solvents, sterilising
by heat or autoclaving, as this will
cause damage.
Precautions are to be taken to
prevent inhalation of harmful dust
or contaminant on the surface or
retained on the filters.
Carefully remove bulk contamination from the
AIR/PRO and wipe down with a damp cloth
containing a mild detergent solution.
Gamma sterilisation is effective
but causes embrittlement of plastic
components and is not recommended.
Replace if deficient after the following checks.
1. Excessive abrasion and scratches on the
visor.
2. The face seal for its seal to the visor and for
holes.
3. Fit and fastenings to the headband.
Scratched or damaged visor may not
offer full protection and therefore
should be replaced.
Specific Instructions for Cleaning
and Disinfection of Visor
Clean with a damp cloth – do not use
hydrocarbons, chemicals, cleaning fluids or
solvents on the visor. If necessary, a mild
solution of washing-up liquid and warm water
may be used.
Clean and sterilise all parts by wiping down
the visor, face seal and headband with visor
wipes (ref. AIR/WIPE)
(Sodium Hypochlorite or Ethylene Oxide Gas
have also been proved effective).
Do not immerse the AIR/PRO in water or any
other fluids.
Do not use organic solvents or abusive
cleaning agents on any part of the the
equipment.
After cleaning carry out the functional test.
Charger Cleaning
Dirt and grease may be removed from the
exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or any
cleaning solutions.
Disconnect the charger from the AC
outlet before cleaning.
Lubrication
Your AIR/PRO requires no additional
lubrication.
To Next Page
Loading...
