COMBI 651
-6-
Sub-base Sets
To obtain a perfect accurate close fitting joint, a
30mm guide bush must be used. The guide bush
must always be fitted concentric with the cutter.
This can be achieved using Trend sub-bases and
30mm outside diameter guide bush ref. GB30.
Trend sub-bases have a central recess to allow
fitting of the Trend guide bush to most makes of
routers and are available ready to fit the most
popular makes.
Two types are offered GB/5 and UNIBASE.
All sub-bases contain screws, a line up bush and
pin. The line up pin and bush ensure exact
alignment of sub-base with router spindle, when
fitted with the relevant collet.
ACCESSORIES
Description Order Ref.
RT/13 Spare blades RB/H (1 off)
RB/H/10 (10 off)
Description Order Ref.
RT/11 Spare blades RB/A (1 off)
RB/A/10 (10 off)
Recommended Cutters
A 12.7mm (
1
/2ā) diameter cutter must be used,
which has a 50mm cutting reach and plunge cut
facility. Router must be plunged in stages of
maximum 8mm in one pass.
Ref. 3/83X1/2TC, 3/83DX1/2TC, TR17X1/2TC,
TR17DX1/2TC, C153X1/2TC, C153DX1/2TC
Fits following router models
Atlas Copco OFSE2000 Bosch GOF 1300ACE, 1600A,
1700ACE Casals FT2000VCE DeWalt DW625EK, 629
Draper R1900V Elu MOF 31, 77, 98, 131, 177(E)
Felisatti TP246(E), R346EC Festo OF2000E Freud
FT2000E Hitachi M12V, M12SA, TR12 Makita 3612BR,
3612(C) Metabo OF1612, OFE1812 Performance Pro
CLM1250R >11/2003, CLM2050R Ryobi RE600N, R600N,
RE601, R500, R502 Skil 1875U1 T-TECH TT/R127
Wadkin R500
Ref. RT/13X1/2TC
Ref. RT/11X1/2TC
Ref. UNIBASE
To Next Page
Loading...
