COMBI 651
-8-
Two heavy duty quick action or
gripper clamps with throats of at least
100mm (4”) are required to secure
the jig to the worktop. Whenever fast
action clamps are used, ensure they
do not foul the router path and that
they are securely tightened.
Panel Connector Bolts
Ref. PC/10/M (
Pack of 10)
Ref. PC/50/M (Pack of 50)
Ref. PC/100/M (Pack of 100)
Ref. PC/1000/M (Pack of 1000)
Panel butt connectors are essential for
connecting worktops. They fit into the recess on
the underside of the worktop and are tightened
with a 10mm spanner. The jig has integral bolt
recess slots to allow the bolt recess to be cut in
the underside of the worktop, using the standard
router cutter. The recess is elongated to allow
easy access for the spanner.
Biscuit Jointer for the Router
Ref. 342X1/2TC
Ref. TR35X1/2TC
Ref. C152X1/2TC
Worktops with inadequate support below them
need additional stability by biscuit jointing the
edges. The biscuit jointing set for the router
together with the No.20 biscuits will ensure
worktops do not sag or warp in time.
Clamps
Ref. FC/200
Two heavy duty quick action or gripper clamps
are required to secure the jig to the worktop.
Flat Biscuit Dowels
Ref. BSC/20/100 (Pack of 100 biscuits)
Ref. BSC/20/1000 (Pack of 1000 biscuits)
Biscuits are used to strengthen the joint. When
used with PVA glue they expand ensuring a tight
joint.
To Next Page
Loading...
