TREND CRT/MK3 - Specialized Routing Techniques

-21-
CRT/MK3
Q Isolate from power supply.
Q Fit cutter.
Q Set back fence position. Fit
some stops to back fence
using cramps.
Q Fit guard.
Q Check all knobs are tight
Q Plug into power supply.
Q Switch on.
Q Drop material against infeed
stop A and pivot into cutter.
Q Feed right to left, until
reaching outfeed limit stop
B.
Q Pivot at outfeed stop.
Q Switch off.
Stopped Moulding
B A
B A
AB
-21-
CRT/MK3CRT/MK3
Q Isolate from power supply.
Q Fit cutter.
Q Set back fence position. Fit
some stops to back fence
using cramps.
Q Fit guard.
Q Check all knobs are tight
Q Plug into power supply.
Q Switch on.
Q Drop material against infeed
stop A and pivot into cutter.
Q Feed right to left, until
reaching outfeed limit stop
B.
Q Pivot at outfeed stop.
Q Switch off.
Stopped Moulding
B A
B A
AB