-22-
CRT/MK3
Q Isolate from power supply.
Q Fit cutter.
Q Adjust angle of mitre fence by loosening knob
and turning protractor head to line up angle
required with arrow.
Q Place component onto mitre fence.
Q Plug into power supply.
Q Feed right to left holding component securely.
Q Switch off.
Mitre Fence
CRT
CRAFTPRO
ROUTER TABLE
MK3
NOTICE: The mitre fence has fixing
holes to allow a spelch block to be
secured using screws (not supplied).
-22-
CRT/MK3CRT/MK3
Q Isolate from power supply.
Q Fit cutter.
Q Adjust angle of mitre fence by loosening knob
and turning protractor head to line up angle
required with arrow.
Q Place component onto mitre fence.
Q Plug into power supply.
Q Feed right to left holding component securely.
Q Switch off.
Mitre Fence
CRT
CRAFTPRO
ROUTER TABLE
MK3
NOTICE: The mitre fence has fixing
holes to allow a spelch block to be
secured using screws (not supplied).
To Next Page
Loading...
