TREND DJ300 - Page 16

2
3
1
DJ300
■ Place the drawer front under the top clamp (1)
and make sure it is flush with the
3
/8” (9.5mm)
timber.
Slide the drawer front until the offset line
aligns with the left edge of the first slot (2).
Clamp the timber securely (3).
■ Slacken the brass thumb screw (1). Using the
spanner supplied (2), adjust the position of
the lock-nuts until the back of the template
slots align with the Template Setting Line (3).
■ Remove the template (1).
Slide the edge guide up against the drawer
front (2).
Tighten the edge guide securing screw (3).
Replace the template.
Edge Guide Setting Line
for the 1/4” (6.35mm)
Dovetail Template
Edge Guide Setting Line
for the 1/2” (12.7mm)
Dovetail Template
1/2” (12.7mm) Dovetail Template
Optional 1/4” (6.35mm) Template
-16-
3
2
1
2mm offset line
3mm offset line
7.5mm
template
setting
line
15mm
template
setting
line
Using
3
/8” (9.5mm)
scrap timber
Using
3
/8” (9.5mm)
rebated scrap timber
3
2
1
IMPORTANT!
Timber must be moved over by
one finger on template in order
to locate edge guide.