TREND DJ300 - Troubleshooting

DJ300
-24-
TROUBLE SHOOTING
■ Tear out - this occurs when cutting across
the grain and can be overcome by scribing
the ends of the timber with a marking knife or
gauge at the height of the cutter.
■ Dovetail joint too loose - increase depth
adjustment of cutter.
■ Dovetail joint too tight - decrease depth
adjustment of cutter.
■ Dovetail joint too shallow - move template
comb towards the jig body by adjusting
locking nut.
■ Dovetail joint too deep - move template
comb away from body by adjusting locking
nut.
■ Clamping bar will not adjust sufficiently
for 23mm plus thickness - remove nylon
spacers and refit clamping knob.
■ Clamping bar will not tighten sufficiently
for 8mm thickness for 1/4” (6.35mm)
dovetails - insert a packing piece behind
clamping knob.
Guarantee
■ The jig carries a manufacturers guarantee in
accordance with the conditions on the
enclosed guarantee card.
Recycling
■ Jig, accessories and packaging should be
sorted for environmentally friendly recycling.