RTS Threshold: Type the RTS (Request-To-Send) threshold in the text box. This
value stabilizes data flow. If data flow is irregular, choose values between 256 and
2346 until data flow is normalized.
Fragmentation Threshold: Type the fragmentation threshold in the text box. If
packet transfer error rates are high, choose values between 1500 and 2346 until
packet transfer rates are minimized. (NOTE: set this fragmentation threshold value
may diminish system performance.)
DTIM Interval: Type a DTIM (Delivery Traffic Indication Message) interval in
the text box. User can specify a value between 1 and 255. The default value is 1.
TX Rates (Mbps): Select one of the wireless communications transfer rates,
measured in megabytes per second, based upon the speed of wireless adapters
connected to the WLAN.
Preamble Type: The usage of the preamble is to limit the packet size of the data to
transmit. It is recommended to choose the short preamble when the link quality is
bad, it is to prevent the wasting time of resending a long packet that is lost.
11g only mode: If Enable, only allow 802.11g WLAN client communicate with
this WLAN Router.
WMM: If selected the Enable, the WMM (Wi-Fi Multimedia Quality of Service)
feature will be enabled.
Antenna Transmit Power: Adjust the power of the antenna transmission by
selecting from the drop down list: full, half (-3dB), quarter (-6dB), eighth (-9dB) or
min.
Wi-Fi Protected Setup
This screen enables users to configure the Wi-Fi Protected Setup function.
To Next Page
Loading...
Need help?
General
