Time: Displays the time and date that the log entry was created.
Message: Displays summary information about the log entry.
Source: Displays the data source.
Destination: Displays the data destination.
Note: Displays the IP address of the communication
Log Setting
This screen enables users to set Router Log parameters.
SMTP Authentication: Select Enable to allow SMTP authentication through the
WLAN router.
SMTP Account: If the SMTP Authentication enabled, fill in the SMTP account
name here.
SMTP Password: If the SMTP Authentication enabled, fill in the password of the
SMTP account here.
SMTP Server: Type your SMTP server address here.
Send from: Type an email address for the log to be sent from.
Send to: Type an email address for the log to be sent to. Click “Email Log Now” to
immediately send the current log.
• E-mail Logs: When log is full - The time is not fixed. The log will be sent when the log
is full, which will depend on the volume of traffic.
To Next Page
Loading...
Need help?
General
