Routing
This selection enables users to set how the WLAN Router forwards data: Static and
Dynamic. Routing Table enables users to view the information created by the
WLAN Router that displays the network interconnection topology.
Static
It enables users to create static routes to other IP networks through next hop
routers.
Network Address: Type the network IP address (ex. 192.168.2.0) of the
destination network.
Network Mask: Type the subnet mask of the destination network (ex
255.255.255.0).
Gateway Address: Type the gateway IP address to the destination network or next
hop router IP address. (ex. 192.168.10.10)
Interface: Select an interface, WAN or LAN to map the static route.
Metric: Type the metric (priority) for the static route (1-15). Metric 1 being the
highest priority.
Add: Click to add the configuration to the static IP address table at the bottom of
the page.
Update: Select one of the entries in the static IP address table at the bottom of
the page, and after changing parameters, click “Update” to confirm the changes.
Delete: Select one of the entries in the static IP address table at the bottom of the
page and click “Delete” to remove the entry.
Cancel: Click the Cancel button to erase all fields and enter new information.
To Next Page
Loading...
