Dynamic
It enables users to enable RIPv1 or RIPv2 (Routing Information Protocol) on all of
the router interfaces, to transmit and/or receive RIP information to and from
other routers also using the RIP protocol. This allows the router to dynamically
learn routes and exchange route information of other IP networks between other
RIP routers.
Transmit:
Disabled: Disable transmission of any RIP information on all the router interfaces.
RIP 1: Enable transmission of RIPv1 information on all router interfaces.
RIP 2: Enable transmission of RIPv2 information on all router interfaces.
Receive:
Disabled: Disable the receiving of any RIP information on all router interfaces.
RIP 1: Enable the receiving of RIPv1 information on all router interfaces.
RIP 2: Enable the receiving of RIPv2 information on all router interfaces.
To Next Page
Loading...
Need help?
General
