© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-815DAP
30
Set the device Repeater mode
Operation Mode
1. Log into your access point management page (see “
Access your access point
management page” on page 7).
2. Click the Operation Mode and next to Operation Mode section drop-down list select
AP Repeater.
3. Select the Repeater Mode to use and click Apply.
Concurrent Dual Band (AP Repeater) mode Site Survey
Wireless > Site Survey
1. Log into your access point management page (see “
Access your access point
management page” on page 7).
2. Click on Wireless and click on Site Survey.
3. Search for your wireless network to extend or repeat in the wireless network list. In
the Select column, click the radio button to select your wireless network.
4. At the bottom, click Connect to connect and copy the settings of the selected wireless
network.
5. If your wireless network requires wireless security, you will be prompted to enter
your wireless key. Enter your Wireless Key required to connect to your existing
wireless network and click Connect.
6. Wait for the device to apply the settings.
7. To verify the access point has successfully copied the settings and repeated the signal
of your wireless network, wait for the Link Status to display Connected. It may take up
to 1 minute for your device to verify and display the connection status.
Note: If the Link Status does not display a Connected status after 1 min, please re-
attempt the procedure.
Concurrent Dual Band (AP Repeater) mode Manual
Wireless > Manual Wireless Setting
1. Log into your access point management page (see “
Access your access point
management page” on page 7).
2. Click on Wireless and click on Manual Wireless Setting.
3. Configure the wireless network and security settings of the repeated signal. Click
Apply to save settings.
To Next Page
Loading...
Need help?
General
