TRENDnet TK-1602R - 2 Installation; Checklist before Installation; Figure 2-1 the 3-1 Combo KVM Cable Is Highly Recommended

TK-802R_TK-1602R Rack Mount KVM Switch User’s Guide July,2004
Page 12
Chapter 2 Installation
2. INSTALLATION
Before installing the KVM switch, you should run through the following peripheral checklist
to ensure a proper setup of your KVM Switch….
2.1. Checklist before Installation
: Suitable cables to connect the KVM Switch to the keyboard, video and mouse
ports of each of your PC. For each computer connected, you should have PS/2
mouse cable (all male) and PS/2 keyboard cable (all male) and a HDB-15 VGA
cable (all male). A 3-in-1 combo cable is highly recommended for your
convenience. For more information on the cable specifications, look up in the
Appendix A.
: A monitor with a standard D-sub 15-pin VGA/SVGA connector
(HDB-15) that will work when connected directly to each of your PCs.
: A standard PS/2 style keyboard. If you are using an AT keyboard with a 5
pin connector you should use a standard AT-to-PS/2 keyboard adapter to
connect to the KVM Switch.
: A PS/2 style Microsoft or Logitech compatible mouse or
a Microsoft IntelliMouse® / IntelliMouse Explorer® compatible
mouse
Figure 2-1 The 3-1 combo KVM cable is highly recommended