TRENDnet TK-1602R - Change PC Name; Reset KVM; Show OSD Menu; Autoscan

TK-802R_TK-1602R Rack Mount KVM Switch User’s Guide July,2004
Page 25
Chapter 3 Operation
<Change PC Name>
OSD
Navigate to the PC Name you desire to change, and then press Enter or Insert key
for editing a new PC name. When done, press Enter to validate the new name.
<Reset KVM>
Front Panel Button
Press and hold down button 1 for at least 2 seconds.
Hotkeys
Reset KVM =
<Show OSD Menu>
Hotkey
Show OSD Menu =
<Autoscan>
Front-panel button
Press and hold down the last button for at least 2 seconds.
The last button could be button 4/8/16 specifically for TK-802R/TK-1602R.
Hotkey
Autoscan =
The autoscan function automatically scans through each connected channel and stay for a
specific time period that is programmable by user (5 ~ 99 seconds). The purpose of autoscan is to
provide you with a quick browsing of the status of all connected channels without tedious manual
switching one by one. You will appreciate this function especially when the there are many
computers connected on your switch.
TO STOP Autoscanning, just press any button on the front panel or hit any key
on keyboard to terminate autoscanning immediately.
Scr
L
k
Scr
L
k
End
Scr
L
k
Scr
L
k
(space bar)
Scr
L
k
Scr
L
k
S