TRENDnet TS-U100 - Leds; Reset Button; Unmount Button

-10-
LEDs
There are three LEDs on the front panel (four for wireless model):
LEDs Description
Power A steady Green light confirms that the storage server is
powered on.
LAN A steady Green light confirms that the storage server
has a good connection to your network.
When it blinks, the storage server is receiving/
transmitting data from/to the network.
WLAN
(for wireless
model)
A steady Green light confirms that the storage server
has a good connection to your wireless network.
When it blinks, the storage server is receiving/
transmitting data from/to the wireless network.
Mode
(green/red)
Off: no devices attached to the storage server.
Green: when you connect a USB device to the storage
server, it starts blinking Green slowly; when the
system has detected the device, it lights Green steadily
to indicate that the attached device is OK.
Red: when you press the Unmount Button to remove
the attached device, it starts blinking Red slowly. If
the last connected device failed, it lights Red steadily;
you have to re-connect the device.
Reset Button
Press and hold the Reset Button for 4 seconds to reset the storage
server.
Unmount Button
Press this button to remove the connected USB device safely.