-12-
Installing the Storage Server
Follow these steps for a trouble-free start of operations of Network
Storage Server.
Connecting to the Network
1. Confirm proper operation of the gateway/hub to be connected in
the network.
2. Connect the storage server to the gateway/hub through the RJ-45
cable.
3. Connect the power adapter of the storage server to the wall outlet.
This will supply power to the storage server immediately.
Connecting to a Client Workstation
For some reasons, you may need to connect the storage server to a
client workstation directly. For example, you build a direct
connection between your desktop PC and the storage server to
configure the storage server. In this event, you should set up the
computer’s IP address as instructions in next section.
Expanding the USB Devices
The storage server provides two USB ports that allow you to expand
the storage server’s function, such as connecting a large storage
device.
To connect the USB device, simply plug the USB device into one of
the storage server’s USB ports. Alternately, you can connect the
USB device through a USB cable.
To Next Page
Loading...
