TriangleTube Instinct Series User Manual

5
CHAPTER 3
CHAPTER 3 - MAINTENANCE PROCEDURES
3.1. Owner Maintenance Procedures
The PRESTIGE must be inspected and ser-
viced annually, preferably at the start of the
heating season, by a qualified service tech-
nician. In addition, the owner maintenance
and care of the unit as outlined in Chapter
2 on page 3 and further explained in this
chapter should be performed to assure max-
imum efficiency and reliability of the unit.
Failure to service and maintain the PRESTIGE
and the system components can result in
equipment failure, resulting in substantial
property damage, serious injury, or death.
The following information provides detailed
instructions for completing the owner main-
tenance items outlined in the maintenance
schedule in Chapter 2 on page 3.
3.2. Daily Maintenance
3.2.1 Check Surrounding Area
Eliminate all the materials listed in Chapter 1
on page 1 from the area surrounding the
unit and from the vicinity of the combustion
air inlet.
If contaminates are found:
• Remove products immediately from the
area. If they have been there for an ex-
tended period, call a qualified service
technician to inspect the unit for possible
damage from corrosion.
• If products cannot be removed, immedi-
ately call a qualified service technician
to re-pipe the combustion air inlet pip-
ing and locate the combustion air intake
away from the contaminated areas.
Failure to comply with these instructions can
result in substantial property damage, seri-
ous injury, or death
WARNING
NOTICE
WARNING
• Verify that the area surrounding the PRESTIGE is
free of combustible / ammable materials or am-
mable vapors or liquids. Remove immediately if
found.
• Verify that combustion air inlet area is free of any
contaminates. Refer to the materials listed in
Chapter 1 on page 1 of this manual. If any of
these products are in the area from which the unit
takes its combustion air, they must be removed
immediately or the combustion air intake must be
relocated to another area.
3.2.2 Check Ventilation Air Openings
• Verify that all ventilation openings to the mechan-
ical room or building are open and unobstructed.
• Check and verify that the vent termination and the
combustion air intake are free of debris and ob-
structions. Remove any debris on the air intake or
ue exhaust openings. If removing the debris does
not allow the unit to operate correctly, contact a
qualied service technician to inspect the unit and
the vent / combustion air system.
3.2.3 Check Temperature Display and Pressure
Gauge
• Ensure the pressure reading on the pressure gauge
does not exceed 25 psig. Higher pressure readings
may indicate a problem with the expansion tank.
• Ensure the temperature on the display panel does
not exceed 194ºF. Higher temperature readings
may indicate a water ow problem.
• Contact a qualied service technician if problem
persists.

TriangleTube Instinct Series Specifications

General

Brand	TriangleTube
Model	Instinct Series
Category	Boiler
Language	English