TriangleTube Instinct Series User Manual

9
CHAPTER 4
CHAPTER 4 - OPERATING INSTRUCTIONS
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights
the burner. DO NOT try to light the burner by hand.
B. BEFORE OPERATING, smell all around the appliance
area for gas. Be sure to smell next to the oor be-
cause some gas is heavier than air and will settle on
the oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas suppli-
er’s instructions.
• If you cannot reach your gas supplier, call
the re department.
C. Use only your hand to turn the external manual
gas valve. Never use tools. If the valve will not turn
by hand, don’t try to repair it; call a qualied service
technician. Force or attempted repair may result in
a re or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualied service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
FOR YOUR SAFETY, READ BEFORE LIGHTING
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
If you do not follow these instructions exactly, a fire or explosion may result,
causing substantial property damage, serious injury, or death.
WARNING
1. STOP! Read the safety information above. This ap-
pliance is equipped with an ignition device which
automatically lights the burner. DO NOT try to
light the burner by hand.
2. Set room thermostat(s) to lowest setting. Turn the
external manual gas valve handle clockwise
to “CLOSE” (valve handle must be perpendicular to
gas piping).
3. Turn the service switch on the appliance control
panel OFF.
4. Remove the front jacket panel on the unit.
5. Wait ve (5) minutes to clear out any gas. If you
then smell gas in the jacket enclosure or around
the unit, STOP! Follow “B” in the safety information
above. If you don’t smell gas, go to the next step.
6. Turn the external manual gas valve handle count-
er clockwise
to “OPEN” gas supply (valve
handle shall be parallel to gas piping).
7. Turn the service switch on the appliance control
panel “ON”.
8. Set room thermostat(s) to desired setting(s).
9. The appliance control panel display will show the
current operating status on the Status Line at the
bottom of the screen. “Standby” means there is
no call for heat (all thermostats are satised). “CH
Demand” indicates a space heating call has been
received. “DHW Demand” indicates a domestic hot
water call has been received. A ame icon will be
displayed when the unit is red.
10. If the unit will not operate, follow the instructions
“To Turn O Gas to Appliance” and call your service
technician or gas supplier.
11. Replace the front jacket panel. Make sure the panel
is seated rmly in place and all mounting screws
are tightened.
1. Set the room thermostat to lowest setting.
2. Turn the service switch on the appliance control
panel to “OFF”
3. Turn the external manual gas valve handle clock-
wise
to “CLOSE”.

TriangleTube Instinct Series Specifications

General

Brand	TriangleTube
Model	Instinct Series
Category	Boiler
Language	English