Seite 38 von 72
• Antenna Setup
a.) Instructions for setting "Permanently fixed antennas"
Satellite: Satellite selection. The satellites are listed, which
are activated in the sub satellite list. Select to edit satellite.
LNB frequency: for the selected satellite set the LNB fre-
quency. Choose Universal or Unicable (SCR). Default set-
ting is universal.
Unicable:
A new window will open.
With IF Channel you can set the corresponding channel, at
Centre Freq. you can set the corresponding frequency .
Example: The first receiver is given IF Channel 1 and fre-
quency 1076 MHz.
The channels and the corresponding frequencies are speci-
fied by the SCR devices (LNB, multiswitch)
Transponder: list of programmed transponder.
DiSEqC1.0: adjustment for multiple satellite reception
22K: Automatically set by the receiver.
Polarisation: default setting is "AUTO". However, horizontal
or vertical LNB supply voltage can be set.
.
b.) instruction for setting „Rotator Antenna“
(Antenna with rotator)
LNB Typ: Set the selected satellite, the corresponding LNB
frequency. Default setting is universal.
Motor type: Sets the type of rotator.
local length/width: Only when "USALS" is selected in Item
rotator type
To Next Page
