Headend Installation
7
Headend installation
You can mount the headend either onto a system rack or directly to a
wall.
Attach the mounting brackets to the headend with the supplied screws.
At the front of the headend.
At the rear of the headend.
Attach the headend to the wall or onto a system rack.
Ensure that min. 10cm ventilation space is available on both
sides and at the front of the headend.
1. Connect an earth cable to the Earth terminal.
2. Attach the other end of the earth cable to an approved ‘earth’
connection point.
3. Insert the supplied cable into the Power Input port.
4. Confirm that the IP address reset dial is set to "0".
Headend installation
8
Resetting the
IP address
The IP address of a headend unit can be returned to the factory
default address by using the IP address reset dial.
1. Turn off the power.
2. Set the IP address reset dial to "7".
3. Turn on the power.
The LEDs flash red and yellow until the process of resetting the IP
address has been completed.
The LEDs show green-constant if the reset process was successful.
1. Turn off the power.
2. Set the IP address reset dial back to the initial setting.
3. Turn on the power.
The IP address has been reset to the factory default.
To Next Page
Loading...
Need help?
General
