1 | Introduction
NAV-900 Guidance Controller Installation Instructions | 11
Preparing the vehicle for installation
1. Park the vehicle on a hard, level surface. Block the front and rear wheels.
2. Align the steering straight ahead. On an articulated vehicle, install the articulation locks.
3. Remove all dirt and debris from the areas of the vehicle where the guidance controller will be
installed.
4. Open all kit boxes and check the contents of the box against the packing list/s. Lay all of the parts out
on a clean workbench.
NOTE – The left and right sides of the vehicle are referenced while standing behind the unit, facing the
normal direction of travel.
Technical assistance
For additional cable guides and information on connecting Auto Guidance Systems or if you have a
problem and cannot find the information you need in the product documentation, go to
https://agriculture.trimble.com/precision-ag/products/displays/ or contact Trimble technical support.
To Next Page
Loading...
Need help?
General
