Safety Information
NAV-900 Guidance Controller Installation Instructions | 5
Cautions
C
CAUTION – When the vehicle has been running, parts of the vehicle, including the engine and
exhaust, can become extremely hot and can cause serious burns. To avoid burns, allow hot
machine parts to cool before you begin working on them.
C
CAUTION – The system installation may bring you into contact with chemical substances, such
as oil, which can cause poisoning. Wash your hands thoroughly after you finish working on the
system.
C
CAUTION – Battery posts, terminals, and related accessories contain lead and lead compounds,
which can cause serious illness. To avoid ingesting lead, wash your hands thoroughly after
touching the battery. Take care not to short-circuit the battery with tools and/or by the incorrect
fitting of cables as fire, burns, and damage can occur.
C
CAUTION – Always wear protective equipment appropriate to the job conditions and the nature
of the vehicle. This includes wearing protective glasses when you use pressurized air or water, and
correct protective welder’s clothing when welding. Avoid wearing loose clothing or jewelry that
can catch on machine parts or tools.
C
CAUTION – Parts of the vehicle may be under pressure. To avoid injury from pressurized parts,
relieve all pressure in oil, air, and water systems before you disconnect any lines, fittings, or
related items. To avoid being sprayed by pressurized liquids, hold a rag over fill caps, breathers, or
hose connections when you remove them. Do not use your bare hands to check for hydraulic
leaks. Use a board or cardboard instead.
C
CAUTION – Do not direct pressurized water at:
- electronic or electrical components or connectors
- bearings
- hydraulic seals
- fuel injection pumps
- any other sensitive parts or components
Set the hose pressure as low as practicable, and spray at a 45° to 90° angle. Keep the nozzle of
the power washer away from the machine at the distance recommended by the manufacturer.
C
CAUTION – To prevent damage to the system, make sure that no wires or hoses interfere with or
catch on any mechanical linkages, or contact any machine parts that get hot.
To Next Page
Loading...
Need help?
General
