Trio MC403 - Introduction; Intended Conditions of Use; Product Specific Requirements

2
INTRODUCTION
Trio Motion Technology products are certied to comply with the requirements
of Annex I to the Directive 2014/30/EU on Electromagnetic disturbance and
Electromagnetic immunity. To achieve this compliance, certain requirements or best
engineering practices must be implemented by the corresponding system designer.
INTENDED CONDITIONS OF USE
Trio Motion Technology products are designed for operation in Industrial environments
with high noise levels that may induce currents or electrical potentials that are
damaging to microelectronics. Our products are nevertheless designed and tested to
withstand the level of electromagnetic disturbance common to these environments, on
the provision that the appropriate EMC guidelines have been employed by a qualied
competent system integrator.
The Trio Motion Technology product range is designed to be integrated, by the
customer, as a control system for industrial machines and auxiliary equipment.
PRODUCT SPECIFIC REQUIREMENTS
Trio Motion’s extensive product and application knowledge combined with product
testing reect that the best immunity is achieved by placing some constraint on the
system into which the product is being integrated. This information is recorded in the
Product Technical Manual (available at www.triomotion.com) and presented in this
document for the commissioning engineer.