RECORDING DATA
The meter can store up to 20,000 readings at an interval rate of 1 to 59
seconds. Each recording session is saved as a data set and each record
is saved with a date and time stamp. This data can be downloaded using
the supplied software.
Setting the interval time
1. Press and hold the button while turning the meter ON.
0001 and Int will appear in the display.
2. Press the LEVEL button to set the sample interval from once
per second to once per 59 seconds.
3. Press the HOLD button to save the interval setting and exit the
setting mode.
Recording readings
1. Press the REC button to begin recording. The REC icon will appear
on the display.
2. Press the REC button again to stop recording.
3. Auto Power OFF is disabled when the record function is active.
Clearing Stored readings
1. Turn the meter OFF.
2. Press and hold the REC button while turning the meter ON.
3. When (clear) appears on the display, release the REC button.
4. All of the readings that were stored in memory are now erased.
BACKLIGHT
Press the button to turn the LCD backlight on or off. To conserve
battery life, the backlight will automatically turn off after approximately
30 seconds.
AUTO POWER OFF
The meter will automatically shut off after approximately 15 minutes of
inactivity. Press the SETUP
button to disable the auto-power-off feature. The icon in the display
indicates that the auto power off feature is active.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
