What to do if my Tripp Lite PINV2000 Inverter is overheating?
If your Tripp Lite Inverter is overheating, allow it to cool down. Ensure that the cooling slots are not blocked and that airflow is not obstructed. Also, reduce the load on the inverter to its continuous rated output.
What to do if my Tripp Lite PINV2000 is overloaded?
If your Tripp Lite Inverter is overloaded, use a higher capacity inverter or a lower rated device.
How to reset a Tripp Lite PINV2000 Inverter?
To reset your Tripp Lite Inverter after a shutdown, switch the ON/OFF/REMOTE switch to the OFF (O) position. Identify and correct the cause of the problem. Then, switch the inverter’s ON/OFF switch to the ON (I) or REMOTE (II) position.
What to do if Tripp Lite PINV2000 shows a low-voltage alarm?
If your Tripp Lite Inverter is showing a low-voltage alarm, start the vehicle to recharge the battery. See Resetting the Inverter for more information.
General| Input Voltage | 12 VDC |
|---|---|
| Output Voltage | 120 VAC |
| Output Frequency | 60 Hz |
| Output Waveform | Modified Sinewave |
| Efficiency | 90% |
| Cooling | Fan |
| Output Power | 2000W |
| USB Port | Yes |
To Next Page
