9
Maintenance
WARNING: Always disconnect from the power supply
before carrying out any maintenance/cleaning.
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause
internal parts to wear quickly, and shorten the machine’s
service life. Clean the body of your machine with a
soft brush, or dry cloth. If available, use clean, dry,
compressed air to blow through the ventilation holes
Brush replacement
The carbon brushes are a consumable item which should
be inspected periodically and replaced when worn. Failure
to do so may result in damage to the motor.
1. With the router disconnected
from power, unscrew the
Brush Caps (2) located on
the front and rear of the
motor.
2. Remove the brushes by
pulling carefully on the
protruding springs.
3. If either of the brushes is worn to less than 6mm
long, they must both be replaced using genuine Triton
replacement brushes - available from Authorised Triton
Repair Centres.
Power cord replacement
If the supply cord needs replacing, the task must be
carried out by the manufacturer, the manufacturer’s
agent, or an authorised service centre in order to avoid a
safety hazard.
STORAGE
• Store this tool carefully in a secure, dry place out of the
reach of children
DISPOSAL
Always adhere to national regulations when disposing
of power tools that are no longer functional and are not
viable for repair.
• Do not dispose of power tools, or other waste electrical
and electronic equipment (WEEE), with household
waste
• Contact your local waste disposal authority for
information on the correct way to dispose of power
tools
MAINTENANCE
925837_Z1MANPRO1.indd 9 08/04/2015 08:48
To Next Page
Loading...
Need help?
General
